DS-M型超细分选机的开发与应用

文章介绍了高效超细粉煤灰专用分级机的研究,在此基础上,重点介绍了DS-M型超细分级机的工作原理及性能特点,分析了DS-M型超细分级机组成的圈流粉磨分选系统的应用效果。实践证明,针对超细粉煤灰分选的选粉机的设计是成功的,在45μm的超细粒径下的分级效率达到80%～90%     

Alkali-activation of marble sludge: Influence of curing conditions and waste glass addition

The use of marble sludge as precursor for new alkali activated materials was assessed studying three different curing conditions (air, humid and water immersion, respectively), after an initial curing at 60 °C for 24 h, and two glass powder fractions additions (2.5 and 5.0 vol%). Microstructural, physical (drying shrinkage, Fourier transform-infrared (FT-IR) spectroscopy, X-ray spectroscopy (XPS)), thermal (differential thermal analysis – thermogravimetric analysis, DTA-TGA) and mechanical (flexural and compressive strength) properties were investigated. Air curing was the most favourable atmosphere for mechanical properties development because it promotes Si-O-Si polymerization and gel densification, as demonstrated by FT-IR and FE-SEM observations, respectively. Satisfactory mechanical properties were achieved (18 MPa and 45 MPa, for flexural and compressive strength, respectively) in particular for glass containing mixtures. Moreover, glass powder addition significantly reduced drying shrinkage of air-cured samples because it operated as a rigid aggregate in the matrix and strengthened the formed gel.     

污水处理中小球藻的自絮凝特性

以BG11(+N)培养基和模拟生活污水为底物,考察了污水处理小球藻(Chlorella vulgaris)的自絮凝特性,探究了自絮凝机理。结果表明:以短沉淀时间运行,小球藻在模拟生活污水中自然形成絮体,沉降性良好;藻细胞表面粗糙,含有丝状、胶状胞外聚合物;絮体内部含有大量短杆菌、球菌;絮体具有相对较高的Na、P、Fe、Ca、Mg元素含量,无机物中主要物质形态为Ca4O(PO4)2。污水处理小球藻的絮凝机理为:基质条件及反应器运行参数等促使藻细胞生理过程发生改变,藻细胞分泌更多絮凝性胞外聚合物增强黏附,生化过程富集P、Fe、Ca、Mg元素改善沉降性,絮凝性细菌大量繁殖促进菌藻共絮凝。     

350MW机组锅炉SCR脱硝系统优化

准东煤田是我国目前最大的整装煤田,但准东煤在锅炉燃烧过程中易发生结焦问题,一般掺烧高岭土缓解结焦。某燃用准东煤350 MW机组,锅炉燃煤掺烧高岭土后烟气携带灰尘颗粒及灰尘量增大,出现SCR脱硝系统烟道积灰严重和喷氨量明显偏大问题,同时在空气预热器形成硫酸氢氨堵塞,使机组不能长周期稳定运行。通过与国内同类型多台机组锅炉对比后发现,脱硝系统均存在易产生积灰的脱硝转向室、催化剂上方及空气预热器入口斜坡积灰状况等情况。针对存在的问题,通过建立改造前、后的模型计算分析,进行了导流板布置的优化设计、CFD流场分布、优化SCR系统导流板设计、声波与蒸汽吹灰器结合吹灰和氨注射栅格优化升级等工作,应用德图480风速仪实测风速试验,发现脱硝烟道原导流板设计不合理及施工安装偏差;原导流板水平段跨距大,支撑不足,造成导流板压塌变形,影响烟气流场分布;锅炉所烧煤质为高钠煤,为防止锅炉结焦掺烧高岭土后,增加了烟气飞灰颗粒及灰尘量,飞灰具有很大黏性,易沉积在烟道导流板及烟道壁面上。因此,提出对脱硝内部各处导流板进行优化改造,对脱硝系统烟道易产生积灰的部位增加声波吹灰器,对喷氨格栅喷嘴数量及氨空混合器升级,同时开展锅炉SCR脱硝喷氨热态优化调整试验工作。通过开展相关工作,SCR烟气系统的烟气流场相对标准偏差优化5%,相同负荷下液氨消耗量降低45%,彻底解决脱硝系统积灰和空气预热器堵塞问题,实现机组满负荷达标稳定运行。锅炉长期运行半年后停炉检查,发现前期脱硝系统烟道高达1 m的积灰部位彻底解决,催化剂表面干净无杂物,解决了脱硝系统积灰问题,同时配合提高空气预热器冷端综合温度的措施,彻底解决锅炉空气预热器堵塞问题。同时,经济效益显著,每年可以分别节约液氨费用70万元,节约风机电耗费用100万元,节约检修清理积灰及检修费用80万元,节约空气预热器冲洗治理费用20万元,综合节约费用270万元/a,达到预期效果实现机组长周期安全经济稳定运行。     

新型“U”型板溶气气浮装置浓缩生化污泥的应用

介绍新型"U"型板溶气气浮装置以及"U"型板的工作原理,重点分析"U"型板溶气气浮对生化污泥的浓缩效果。在不同的污泥负荷、溶气回流比、PAC以及PAM加药量的情况下,进行气浮中试试验,寻找最佳的试验工况。试验结果表明,当污泥负荷为57 kg/(m^2·h)、溶气回流比为35%、PAC加药量为30 mg/L、PAM加药量为8 mg/L时,气浮出泥的污泥含固率能稳定在5.55%左右,"U"型板溶气气浮对生化污泥的浓缩效果很好。这对实际生产中气浮工艺取代二沉池以及重力浓缩池提供了现实可行的指导意义。     

Reduction of chlorophenols and sludge management from paper industry wastewater using electrocoagulation process

ABSTRACT

In this study, electrocoagulation (EC) was used to determine the optimum conditions on the basis of maximum chemical oxygen demand (COD) and color removal. At the optimum conditions chlorophenols (CPs), biological oxygen demand and total organic carbon (TOC) were determined. The biodegradability of wastewater was increased significantly with 63% COD, 98% color, 61% TOC and overall 65.51% reductions in CPs. Further, the electro-coagulated sludge was characterized by using different analytical techniques to assist the physicochemical and elemental phases, to find-out better management option, reusability for plant growth and safe disposal. Additionally, aluminum content (70.62%) was successfully recovered from sludge.     

Reduction of waste biosolids by RAS-ozonation: Model validation and sensitivity analysis for biosolids reduction and nitrification

Biosolids reduction model by return activated sludge ozonation was validated by simulating nitrification data compiled from our pilot-scale and the literature studies. Then, a global sensitivity analysis (GSA) was performed to identify influential and non-influential parameters for biosolids reduction efficiency, change in specific nitrification activity (SNA), and alteration to expected nitrification stability. In general, the model outputs were sensitive to operational and ozone reaction parameters, but not to biochemical parameters. For operational parameters, mainly temperature and initial solids retention time (SRT) influenced all model outputs. For biosolids reduction, increase in the degradability of the influent COD decreased the reduction efficiency. For SNA, the changes were highly dependent on the influent TKN/COD ratio. Our findings also imply that the stability of the nitrification process in ozonated systems should be enhanced at constant MLVSS for warm temperatures, but could be reduced at temperatures below 12 °C and aerated SRTs below 10 days.     

油田含油污泥处理技术研究进展

含油污泥处理是目前油田亟待解决的问题之一。介绍了国内外含油污泥处理技术的研究进展，主要处理技术有溶剂萃取处理技术、焚烧处理技术、热解处理技术、生物处理技术、调剖处理技术等，并介绍了国内部分油田的含油污泥处理工艺。     

PLC控制在气力除灰系统的应用

本文根据攀钢发电厂除灰系统的控制性能要求,采用“上位机+PLC”组成的控制系统实现对除灰系统的控制.该控制系统具有抗干扰能力强、可靠性高、操作简便、扩展方便等优点.